CP Electronics ELLIPSE White Wall Mounting Pushbutton Time Lag Switch With 10 Sec -20 Min Time Delay Function 10A

CP Electronics ELLIPSE White Wall Mounting Pushbutton Time Lag Switch With 10 Sec -20 Min Time Delay Function 10A

The ELLIPSE and KH2 time lag switches are a quick and effective way to reduce energy consumption for lighting applications. Pressing the button or touch pad brings the lights on; the lights will then switch off automatically after a preset time period has elapsed.

These units do not require a neutral connection, therefore they can be used to replace an existing light switch. The duration of the time delay is set by a thumbwheel on the reverse of the unit.

 

The ELLIPSE/TN and KH2N have neon illumination to allow the unit to be located in the dark.

 

Time lag switches can be used in two way and intermediate switching arrangements without any extra wiring.

 

 

LOAD

10A of lighting including incandescent, fluorescent, compact fluorescent, low voltage (switch primary of transformer).

Fluorescent and compact fluorescent fittings with “switch start” ballasts - 10 ballasts maximum.

Power factor correction capacitors must be fitted.

Most fluorescent fittings have power factor correction capacitors fitted. If they are not present the unit may fail to turn off properly or flicker. In this case fit one capacitor per circuit with a minimum value of 1μF for every unit installed. The capacitor should be fitted across switched live and neutral. Note that it is not necessary to fit a capacitor on every fitting. This also applies to fittings controlled with high frequency ballasts and maintained emergency fittings.

Not suitable for switching contactors

Not suitable for SON lighting

Not suitable for heating or ventilation loads.

 

 

SUPPLY VOLTAGE 220-240 Volts AC 50 Hz

TIME OUT PERIOD 20 seconds to 20 minutes (approximate)

FIXING METHOD Surface fixing 25mm deep plastic surface mount moulded box. Flush fixing 25mm steel wall box or 32mm deep cavity wall box.

TERMINAL CAPACITY 1.5mm²

MATERIAL Flame retardant ABS

TYPE Class 2

TEMPERATURE -10°C to 35°C

CONFORMITY EMC-89/336/EEC, LVD-73/23/EEC