CP Electronics ELT10 White Automatic Key Operated Emergency Lighting Test Switch 6A

CP Electronics ELT10 White Automatic Key Operated Emergency Lighting Test Switch 6A

The ELT10 emergency lighting test switch is designed to test the function of emergency luminaires. A key switch is used to interrupt the supply to the luminaires for a pre-programmed period of time. At the end of the time period the supply to the luminaires is automatically re-instated. The result is that there is no risk of depleting the batteries in the emergency fitting.

Three pre-programmed test intervals are available:

• 10 minutes

• 1 hour

• 3 hours

 

The unit will power up with the SUPPLY ON lamp illuminated—the supply will be connected to the output.

 

Turn and release the key switch to select the 10 minute test interval. Turn and release again to select the next test interval—the supply will be disconnected from the output for the duration of the test.

 

To cancel a test, turn and release the keyswitch until the SUPPLY ON lamp illuminates.

 

LOAD

10 Amp incandescent lighting

6 Amp fluorescent lighting

3 Amp compact fluorescent lighting

3 Amp low energy lighting

3 Amp low voltage lighting (switch primary of transformer)

Fluorescent lighting (max 6 fittings recommended)

For fluorescent lighting total power factor correction capacitance must not exceed 40μF

 

SUPPLY VOLTAGE 220-240 Volts AC 50 Hz

TIMING PERIOD 10 minutes, 1 hour, 3 hours

FIXING METHOD Surface fixing 25mm deep plastic surface mount moulded box. Flush fixing 25mm steel wall box or 32mm deep cavity wall box.

TERMINAL CAPACITY 2.5mm²

MATERIAL Flame retardant ABS

TYPE Class 2

TEMPERATURE -10°C to 35°C

CONFORMITY EMC-89/336/EEC, LVD-73/23/EEC